Audi Allroad Quattro

November 2022, 2005 audi allroad 2.7T diagnosed fire/melting of lightbulb of the passenger side headlight due to electrical issues. Was unable to repair the headlight at that time. November 2023, owner of vehicle finds open recalls associated with this make/model. Since the recalls were dated back to 2006 or 08, so the VIN tools only show up to 15 years. I made an recall repair appointment with my local Audi. When I called to make sure they had the parts for the repair they said there are…

During recent heavy rains, all of a sudden the car's transmission that had been working fine, after having been parked briefly pointing slightly down hill, no longer functioned properly, and had apparently gone into LIMP Mode. after talking with Mechanics and doing research, we checked the carpet areas and determined and documented the car's interior was very wet, both in front and in the rear areas, with evident moisture and corrosion under the battery and cabin air filter areas and rear…

please see prior form submission re transmission...please confirm receipt of earlier entry.

The contact owns a 2014 Audi Allroad. The contact stated while driving 65 MPH, the Electronic Power Control (EPC) and check engine warning lights illuminated. The contact stated the vehicle went into limp mode and he started hearing an abnormal noise. The contact stated that the vehicle stalled but he was able to park on the side of the road. The contact was able to restart the vehicle within 10 minutes but continued to experience the failure multiple times until he was unable to restart the…

TL* THE CONTACT OWNS A 2003 AUDI ALLROAD. THE CONTACT STATED THAT THE AIR BAG WARNING LIGHT WAS ILLUMINATED. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC WHERE IT WAS DIAGNOSED WITH NEEDING CLOCK SPRING TO BE REPLACED. THE VEHICLE WAS REPAIRED HOWEVER, THE FAILURE PERSISTED. THE MANUFACTURER WAS NOT INFORMED OF THE FAILURE. THE FAILURE MILEAGE WAS APPROXIMATELY 135,000.

TL* THE CONTACT OWNS A 2005 AUDI ALLROAD. THE CONTACT STATED THAT THE TIMING CHAIN MADE AN ABNORMAL SOUND WHILE DRIVING. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC WHERE IT WAS DIAGNOSED WITH NEEDING THE TIMING CHAIN TO BE REPLACED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOT INFORMED OF THE FAILURE. THE FAILURE MILEAGE WAS APPROXIMATELY 185,000.

TL* THE CONTACT OWNS A 2013 AUDI ALLROAD. THE CONTACT STATED WHILE AT A STANDSTILL, THE VEHICLE FAILED TO START. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC WHERE IT WAS DIAGNOSED WITH NEEDING THE TIMING CHAIN TO BE REPLACED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS BEEN INFORMED OF THE FAILURE BUT PROVIDED NO ASSISTANCE. THE FAILURE MILEAGE WAS APPROXIMATELY 110,000.

A CHECK ENGINE LIGHT AND DTC LIGHT CAME ON THE DASH WHILE DRIVING, BUT THE CAR HAD NO SYMPTOMS OF FAULT OTHERWISE. DURING ONE FOLLOWING DAY, I WAS IN THE GARAGE WHERE THE CAR WAS PARKED, WAS NOT RUNNING AND UNLOCKED WITH KEYS INSIDE, AND SMELLED AN ELECTRICAL FIRE. I OPENED THE HOOD AND FOUND A SOFTBALL SIZED FIRE BURNING FROM AN ELECTRICAL CONNECTOR COMING FROM THE SIDE OF THE ENGINE. AFTER PUTTING THE FIRE OUT, I FOUND A BLOWN 'ENGINE MANAGEMENT' FUSE WHICH MAY BE ORIGINALLY TRIGGERED THE…

I WAS DRIVING MY CAR AND FELT MY BACK IN PAIN/BURNING. THE HEATED SEAT ELEMENT HAD CAUGHT THE SEAT BACK ON FIRE AND BURNED A HOLE THROUGH THE SEAT AND BURNED MY SKIN. LUCKILY, I WAS ON A CITY STREET WITH A SPOT ABLE TO PULL OVER IMMEDIATELY, TURN OFF THE CAR, AND SMOTHER THE FLAME WITH MY JACKET. I THINK THIS IS EXTREMELY DANGEROUS. HAD I BEEN DRIVING AND UNABLE TO PULL OVER THIS WOULD HAVE BURNED ME MUCH WORSE OR CAUSED AN ACCIDENT. I AM EVEN MORE CONCERNED BECAUSE WHEN I REPORTED IT TO AUDI…

ESPECIALLY IN COLD WEATHER, STEERING INTERMITTENTLY DEVELOPED RESISTANCE AT CENTER POINT WHILE IN MOTION - FROM 30 MPH ON UP. STEERING WOULD NOT STAY POINTED STRAIGHT AHEAD, WOULD KICK OFF TO ONE SIDE OR ANOTHER. PROBLEM WOULD GO AWAY IF CAR WAS TURNED OFF AND ON, ONLY TO REOCCUR. PROBLEM WAS DIAGNOSED AS INTERNAL STEERING RACK FAULT CAUSING STEERING SHAFT TO HEAT UP AND BIND. SOLUTION WAS TO REMOVE AND REPLACE ENTIRE RACK ASSEMBLY AND STEERING KNUCKLE.